Android Tablets Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Hello Guys,

I hope you can help me. My tablet (eken A90 advanced) has an dead Area about 2cm from the right about 1cm wide.

With every firmware so far I had no success and I already opened the tablet and see if all connectors are okay. These guys seem to have the same problem although it is a different tablet.

http://www.slatedroid.com/topic/30767-hardware-defect-unresponsive-area-in-u9gt2-touchscreen/

I think this tablet has the goodix f5tx touchscreen sensor.

I hope anyone has/had the same problem and can help me.
 

·
Registered
Joined
·
28 Posts
I had similar problem - similar area, with ft5x touchscreen, too- also a dead "stripe" about 50px wide. no firmware, no calibration apps, no software methods could change that. seemed a hardware error, RMA'd it and had my tablet replaced with a new one. fortunately I didn't have to send it back to China, but everything was done by a local dealer.
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #4 ·
Just bought a replacement here :

http://www.aliexpress.com/snapshot/206663278.html

It isn't the same as before bur it works with the eken a90 with cm10 and 907c compability zip. The touchscreen is even a lot better. It detects movement much more precise. Before it only detected like every 4-3mm and now i can't even see it. I activated show touch coordinates in cm10 for this.

Overall I#m very happy as the experience is much smoother now.
 
1 - 4 of 4 Posts
Top