Android Tablets Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
hello my name is kostas from Greecei have buy 5 days ago a zt180 10,2" i want to flash the 809rom .i have a usb to usb cable(digitus dn3004) drivers and all the software i needbut when i connect the pad in the pc nothing happens .i have install the usb to usb cable drivers i put the epad in flash mode but nothingany help????thanks
 

·
Registered
Joined
·
131 Posts
[quote name='KOSTAKEF;35862]hello my name is kostas from Greecei have buy 5 days ago a zt180 10' date='2" i want to flash the 809rom .i have a usb to usb cable(digitus dn3004) drivers and all the software i needbut when i connect the pad in the pc nothing happens .i have install the usb to usb cable drivers i put the epad in flash mode but nothingany help????thanks[/QUOTE'] Firstly you need to plug from a USB on your PC to the otg port on the pad, then press the large button at the front and the power button at the same time this will allow the pad to be recognized as a new device by the PC then you need to install the secbulk.sys file that is available in the older firmware.
 

·
Registered
Joined
·
8 Posts
for flashing with the otg port you can use a normal USB Type-A to USB Mini-B Cable (eg. Digicam, Mobilephone Datacable etc)!
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #4 ·
[quote name='epatux;35894]for flashing with the otg port you can use a normal USB Type-A to USB Mini-B Cable (eg. Digicam' date=' Mobilephone Datacable etc)![/QUOTE']Thanks a lot it is succesfuly flashed rom 809
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top