[grzecho]

Hi all, I have m001 since 2 months. It is used by my son (5 year old) and he dropped it once. fter that I see red artifacts which shows dynamicaly from right to left border of the screen. When I squeeze the device, they disapear. When I unscrew back part, the device works great. What should I to? Best regards,Grzegorz

 

[tarpez]

Sounds like you need to reseat the video ribbon. There is a post with pictures somewhere. Anyway I had the same problem and reseating the ribbon into the connector fixed.

 

[grzecho]

I reseated ribbon but when I close the device, after 1 - 2 seconds this red artifacts shows again. The only way to make screen clean is to not close back. What to do?

 

[Mike]

Be careful when fiddling with the video ribbon, it's very touchy and if you don't get it in perfectly then the display will not work at all.

 

[grzecho]

I've tried several times (15+) to reseat the ribbon but after putting all things together, red artifacts showed again.

 

[bitrate001]

I experienced exactly the problems you describing. Everything was fine until I tried to mount the back panel. I solved it by fixating the video ribbon on top of the touch screen with hot glue. I'm sure you can fixate it with tape as well.Regards

 

[grzecho]

I experienced exactly the problems you describing. Everything was fine until I tried to mount the back panel. I solved it by fixating the video ribbon on top of the touch screen with hot glue. I'm sure you can fixate it with tape as well.Regards

do you have photos? Can you post them? It would be very hapefull.