Android Tablets Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
I've been experiencing a similar problem with my m009s after installing the latest firmware from this page.

I found that somehow after installing new firmware, the tablet is actually still doing something that isn't visible. What I now do every time I finish installing a new ROM is the following:
- Disconnect the USB-cable;
- Hold the power button for approximately ten seconds. This seems to turn the device of properly, even though you can't see anything change;
- Start the tablet as I normally would by pressing the power button for about 2 seconds.

I have the latest MID model, so I don't know if this solution applies to this topic specifically, but I'd say it's worth a shot.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top