Android Tablets Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi,we have a problem with a M003,the tablet when switches on the Android figure comes up then thats it,nothing no indicator bar underneath or anything just sticks.Supplier says must download flashware/firmware to SD card then pop in M003 and that will solve it. Just wanted to check on here first to see if this is right and which firm/flashware is correct and what procedure should be taken as never done this before.Any help would be really,really appreciated.thanks
 

·
Super Moderator
Joined
·
3,234 Posts
That's just right. All you can do is to re-flash your M003. Download the M003 Firmware from this forum's download section or from my server: http://www.slatedroid.com/community-android-news/6089-i-created-open-android-account-my-server.htmlYou need to follow thise steps:1. Download the Firmware;2. extract the firmware archive 3. copy the whole folder script to your MicroSD card4. place the MicroCD card in the card slot of the M0035. Turn ON the M0036. wait for the screen message to remove the MicroSD card and do so.After the M003 will restart, all should be fine.
 

·
Registered
Joined
·
66 Posts
[quote name='martsb;52619]Hi' date='we have a problem with a M003,the tablet when switches on the Android figure comes up then thats it,nothing no indicator bar underneath or anything just sticks.Supplier says must download flashware/firmware to SD card then pop in M003 and that will solve it. Just wanted to check on here first to see if this is right and which firm/flashware is correct and what procedure should be taken as never done this before.Any help would be really,really appreciated.thanks[/QUOTE'] Hi pisthai is right in what you need to do, you will find a you tube video to watch that shows how to carry out the instructions an flash your unit. here is the address: YouTube - EKEN M001 M002 M003 ANY ROM Installation Tutorial , it's called "EKEN M001 M002 M003 ANY ROM Installation Tutorial". Good luck, just make sure you have the power connected to the M003
 

·
Super Moderator
Joined
·
3,234 Posts
[quote name='martsb;53204]hi pisthai' date=' Thank you for your help,was getting a bit worried nobody was going to answer,thank you[/QUOTE'] [quote name='martsb;53748]Thank you to both' date='very grateful for advice.[/QUOTE']Hopefully you're on the right track now and get use of the new Firmware as well.Don't worry about the time we sometimes need to answer. And sometimes we also didn't read all as carefully as we should. Don't forget the difference in time as well!Good luck.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top