Android Tablets Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
74 Posts
Hello guys,

I have been trying this

usb debug off
tablet still on
volume up or down,
reset button

OR

usb debug off
tablet off
volume down & power
hold for about 6 seconds, as you see the PIPO text, let go power then volume down
The Green android man with chest open and a red yield sign with an exclamation appears...

is this flash mode? if so, the computer makes a noise when the usb is connected, but the RKAndroidTools v1.35 does not find the device.

but I have not been successful in doing this.
is that what youve been doing? does it work?
Cheers,
Mark.
 

·
Registered
Joined
·
208 Posts
I can't tell which Pipo you have. I have the M3 and for mine (I assume it is the new board) I have to press volume + and the reset button. However, this needs to work with the instructions from Roman from his website. Here is the link. It tells you how to do it for the M1, but it is exactly the same for my M3 (wifi only edition) but you have to press volume + and reset, NOT volume - and reset, as in his guide.

http://www.topnotchtablets.com/support is for the img file and further down are the instructions. Make sure you check to make sure you have the new board though and obviously you flash at your own risk.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top