Android Tablets Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
35 Posts
From the illustration in CircuitDB (http://www.circuitdb.com/articles/17/5, bottom), I was able to locate the battery:LP455590P5H : 3.7v 2300mAh Lithium Polymer cell. Standard Discharge. w/ E-Z solder tabs.so a 2-unit set (like the one in the M003), would run about $40.I've read here in the forum that the case has room to add this battery set, but I'm unsure how to wire it in. Given the 7.6v output, the 3.7v batteries must be in series, so I imagine the second pack would be wired in parallel.Any instructions?TIA
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top